Maximum Motorsports Stainless Brake Hoses & Hard Lines, 1986-93, SN95 calipers, rear MMBK13R

Maximum Motorsports
Availability: Out of stock

Plumbing kit for 1986-93 Mustang 5.0L rear disc conversion using 1994-04 OEM SN95 calipers and rotors. Kit includes stainless steel hard lines and 2 braided stainless steel PTFE-lined hoses.

This brake line kit will make your life much easier when swapping 1994-04 Mustang rear brakes onto a Fox Mustang rear axle. The unique stainless steel hard lines in this kit were designed by Maximum Motorsports to fit the 1979-93 Mustang chassis. The lines and hoses clear the stock Fox chassis bumpstops, the quad-shock brackets on the 8.8" axle housing, and a rear coil-over conversion. This kit eliminates the problems caused when trying to reuse drum brake hard lines with a disc conversion, and avoids the interference encountered when using the 1994-95 Mustang axle hard lines on a Fox chassis.

Kit includes

  • Two braided stainless steel PTFE-lined brake hoses for caliper attachment
  • Two stainless steel hard lines, pre-bent for 8.8" axle
  • Two fluid bolts for OEM Ford SN95 calipers
  • Copper sealing washers
  • Brackets, clamps, and hardware required for installation
  • Complete MMBK13R installation instructions

Does not include:

MM also carries high performance brake fluid.

Braided stainless steel hoses are considered a safety requirement for any car that is raced. The high heat generated during track use has been shown to cause failure of conventional rubber hoses.

Maximum Motorsports was the first with direct replacement stainless steel braided brake hoses for Mustangs, offering them since 1993.

Features of MM brake hoses

  • The hose end is designed to swivel at the chassis prior to tightening. This allows perfect alignment between the chassis hose-mounting tab and the caliper's banjo fitting.
  • A brake fluid-resistant clear urethane covering helps protect the stainless steel braid.
  • DOT approved